TTB leveling
I have a 97 ford f250 4x4 CCSB and I wanted I bought a 3.5" leveling kit for it basically just an extra leaf spring pack to put under the existing leaf springs I believe i can also take some of them...
View ArticleTs chip, weird shifting?
Hi, I have a 97 F-250 and i just installed a ts chip with the "canned tunes" the truck is basically stock so I figured these would be fine for now, but the question i have is the shifting with the...
View Article4X4 HELP!
I have just purchased a 97 250 4X4 7.3l and my 4X4 will not engage. I have looked into a few things and now need help. When shifted into 4X4 the front driveshaft does turn while moving in forward and...
View Article5.6k MOD HELP PLZ!!
I have a 94.5 F350 psd zf5. Today attempted the 5.6K mod, wired in series to the signal wire, to a switch, and back to the signal wire. With the truck running i have 14.3v at the signal wire and when i...
View ArticleAre 96 ford f250 wheels hub or lug centric
Hi, i have been wanting to put spacers on the back wheels of my 96 f250 7.3 as the rear axle is narrower then the front axle but havnent had the time to take the wheel off and check if they are hub or...
View Article96 F250 2wd HELP
Long story short, I am trying to figure out how to get an extra couple inches of clearance in the front wheel well of this truck to accommodate the 285/75/16's that are on it. Or find a different...
View Article97 Regular Cab HYDRA Help
I have a 97 F350. Its 4x4 automatic with a PCM number NAW 6. I just got my hydra in the mail and am wanting to put a high idle tune and some other on it. With my Box/Hex calibrations for my trucks pcm,...
View ArticleAdvice and experiances on tuners for 97 7.3l
I am looking for advice and experiences on tuners for my 97 F250 7.3l. I currently have the full Banks kit installed; intercooler, 4" exhaust, 1.0 Banks turban housing, Banks chip and trans commander....
View Article1996 F350 Crew Cab Powerstroke
Hi All I am tryting to install a daytime running light module on a US truck - 1996 F350 Crew Cab Powerstroke Dually and i need your help as i cant find the info using google. Any help would be much...
View Article1997 7.3 manual, injector issue.
I ordered what I was led to believe were stock injectors for my California truck. What I received were AA's. My cores were AB's. This issue was not caught in time and installed in truck. Truck runs...
View ArticleClik here to view.
Bad e4od to zf5
E4od with 320k on it has finally the bed. Been looking at rebuilding, looking at reman, considered rebuilding myself and looking at built autos but can’t make up my mind on how much money I can/want to...
View Article1997 Rear leaf spring swap
Hello everyone, I hope everyone is having a good day. I have a 1997 Ford F350 7.3 2 wheel drive crew cab. I have been reading a lot about swapping out the rear leaf and axles for the '05+ super duty...
View ArticleIrate efuel problems
Hey, I am new here. I just installed an Irate efuel system. First, where do you guys connect the yellow wire, the key on wire. Directions say to put it in the idm 30a maxi fuse. I did but the pump runs...
View ArticleHydra chip help!
Hello everyone! Not sure if this is the right forum to ask this question but here goes. I’m trying to help my husband program these custom tunes that thoroughbred diesel sent us through email. So I...
View ArticleNo wait to start after E-Fuel conversion
Just finished up my e-fuel conversion. All wires are connected and fuses are not blown. There is power to everything, but I have no wait to start light and it just cranks with no start. Anyone have...
View ArticleCcv mod good or bad?
I’m going to be installing a KC turbo and was wonder if I should delete the Ccv. To me It seems to lube the turbo up some. Any thoughts is this good mod to do or bad. I don’t k ow the pros n cons of...
View Article1995 7.3 turbo rebuild+++
Hey all. I'm currently in the process of rebuilding my stock 1995 7.3 turbo. I ordered a kc assembly, php hydra tuner, pedastal delete kit, and an edge 3 monitor (think I ordered wrong monitor). Anyhow...
View ArticleE-fuel question.
Installing an e-fuel regulated return system on my 97 f250. I want to reuse the original 5/16 supply and return metal lines. But I am planning on installing stage 1.5 injectors down the road. Will the...
View ArticleE fuel
I have the driven diesel E fuel system. The other night the truck dies like it ran out of fuel. the pump seemed to stop working. fuel pressure gauge was at 20psi. I cycled the ignition a few times and...
View Articletranny temp gauge
I have a 95 7.3 powerstroke with an e4od trans and I was looking for a tranny temp gauge I could put in the cab. can anyone give me ideas or what gauge I could buy. I've heard there's a spot on the...
View Article